Edge Products 38406 CS2, CTS2 & CTS3 Pillar Mount

•The color is not very close to the factory color. There is a noticeable difference. •The bottom of the gauge pod part hits the dash preventing installation. In order for it to work, I had to grind away some of the plastic under the gauge pod piece just so I could install it. It still hits the dash even after grinding. Then had to force it back pretty hard just to install the new bolt. •And the fit isn't very good everywhere else either. There are gaps where it should be touching the original pillar plastic. And the back side of this thing hits the windshield so it vibrates with some tones of the truck. I'll have to pull that back out and grind it away so it doesn't hit the windshield anymore. •It's a cool idea, and I would probably like it better if the color was closer to factory and fit properly. I already modified it, so I guess I'm keeping it, because I doubt they'd return it. •If I could have a do over I would get the full length single pillar pod and just install the CTS2/3 mount piece into the pod hole. At least it would be one piece, meaning one solid color. And it wouldn't have gaps hanging out. I just don't know if the CTS2/3 mount will mount into a standard gauge pod or not, since it's a sandwich type clamp and needs the right size of lip to mount correctly.

Easy to install. Works great for my CTS2. I needed more dash space for my 5th wheel camera monitor. As most others have stated, the screw is too short. I picked up a longer screw at ace hardware. Would be 5 stars if it had the correct length screw.

Only good thing is that it hold my programs, other than that it looks bad and cheep 10/10 WOULD NOT!!!!! Recommend for this price maybe if it were like $30