Pusher 67IMSCC 3.5" MEGA Intake Manifold
Manufacturer Number: 67IMSCC
XDP Part Number: PU67IMSCC
10-12 Dodge 6.7L Cummins (Cab & Chassis)
* denotes required field
Number of Ports*
|The Pusher 67IMSCC 3.5" MEGA Intake Manifold for the 10-12 Dodge 6.7L Cummins 4500/5500 are built around a 3.5" inlet that smoothly transitions to two 3" mandrel bent tubes. This design also enabled the use of a short bolt in place of the long driver-side flange bolt that passes right through the center of the stock manifold air plenum. Thus freeing up airflow even more yet maintaining the stock six bolt pattern for a proper seal. The twin tube design nearly doubles the outlet size of the stock manifold while minimizing the impact of the initial section of the number one injector line. These design features amount to a 49.4% increase in flow over the factory manifold. With this vast improvement over the stock manifold you can expect quicker turbo spool, lower egt's, and less over all strain on your motor. This manifold also includes instructions, a polished stainless dipstick mount, port plugs, a factory Cummins gasket and hardware to make installing this intake extremely easy. You will need to delete all of your factory emissions equipment as this manifold does not have provisions to use any of it. This manifold is for off road use only.
You will need to delete all of your factory emissions equipment as the
manifold does not have provisions to use any of it. This manifold is for
off road use only.
- Unobstructed 3.5" inlet to two 3" mandrel bent tubes.
- Fully TIG welded with precise settings
- 50-200 degrees F drop in EGT's
- .5-1 MPG increase
- Deletes constrictive emissions equipment
- Significant gain in throttle response
- Faster turbo spool