other brother (Washington st) | September 10th, 2008
Horrible product! Doesn't fit right, only uses 1 screw to attach it when the factory pillar has 2 screws & 3 or 4 snap in clips & a hook on the bottom to hold it tight to the dash. This thing is floppy loose when installed, doesn't follow the lines of the windshield / body pillar. I brainstormed hard to try & figure out a way to secure it to the vehicle & make it work but I couldn't come up with anything. This is on a 05 2500 ram.
dick Beater (texas) | November 11th, 2008
appartly other brother is stupid and overtightened his pod
04 dodge 2500
andrew (Kentucky) | August 18th, 2009
good ideal but doesnt fit well. doesnt follow line of the window and can see inside of the mount threw the windshield.
Ask XDP a Question about this product (Allow 24-48 hours for reply)
Most Popular Questions
Will an Edge CTS monitor fit this?
View Staff Answer
No, the CTS will not work with the Auto Meter 13006 Edge Attitude Mount w/ Single Gauge Pillar Pod. The Pod will only work with the Attitude Monitor (Legacy Version).
When installing this item, would I loose grab handle?
View Staff Answer
Yes, you would lose the factory grab handle. This product replaces the factory pillar which gives it a clean and stock look. Please refer to the installation instructions obtained directly from Autometer which I have provided below.
TAKE 10% OFF SITEWIDE* WITH OUR VETERANS DAY SALES EVENT!
Enter the code at checkout and a 10% discount will be applied to your order.
USE CODE: VET10
Valid for all orders over the phone or online, *excluding the manufacturers listed in the company policy.
You will still receive FREE SHIPPING on purchases over $50! This promotion is valid now - 11/11/19 only.