Morimoto BAF000H 2/4Banger Bar Power Harness (2 Pods)

Wire the new lights on your vehicle with the Morimoto BAF000H 2/4Banger Bar Power Harness (2 POD) from XDP. The Morimoto 4Banger LED Pods have been developed from the ground up to set a new standard in their segment, and the same goes for the wiring. Not one component on the harness was overlooked for the sake of cost or simplicity. Triple sealed proprietary 4-pin relay with hanger. Proprietary over-molded inline fuse holder with 20A mini fuse. DT06-2S female outputs with dual seals. Stainless steel power and ground terminals. Proprietary M-Spec push button switch with Yellow-LED backlight. All wiring is properly sized and relays rated for flicker-free, reliable power delivery. Every line of the 16 awg copper wiring is protected with black mesh insulation. Every connector has been over-molded, sealed, or protected with heavy duty heat shrink. The connections on the harness have been laid out in a logical way to power an LED pod on each side of your vehicle. There are two Deutsch outputs. A positive battery terminal, and ground terminal, and a switch. The wiring for the in-cabin push button switch has an in-line barrel connector that drastically improves ease of installation, since you don't have to jam the switch mechanism through the firewall. While this harness is a perfect match for the Morimoto 4Banger LED pods, you can make good use of it with any other off-road lighting setup that takes a DT-style two-pin input (which is basically the industry standard).

Features:

• Connects 2 LED Pods
• Triple Sealed Proprietary 4-Pin Relays With Hanger
• Proprietary Over-Molded Inline Fuse Holder With 20A Mini Fuse
• DT06-2S Female Outputs With Dual Seals
• Stainless Steel Power And Ground Terminals
• Proprietary M-Spec Push Button Switch With Yellow-LED Backlight