Products Showing Parts for — {{ }}

No Results Showing Parts for — {{ }}
Part #: PU67KIT2G

Pusher 67KIT2G 3.5" MEGA Intake System

2010-2012 Dodge 6.7L Cummins
Part #: PU67KIT2G
Step 01 / 04
Our Recommendations Compatible Products
Scroll to View More


The Pusher 67KIT2G 3.5" MEGA Intake System for your 10-12 Dodge 6.7L Cummins is built around a 3.5" inlet that smoothly transitions to two 3" mandrel bent tubes. This design also enabled the use of a short bolt in place of the long driver-side flange bolt that passes right through the center of the stock manifold air plenum. Thus freeing up airflow even more yet maintaining the stock six bolt pattern for a proper seal. The twin tube design nearly doubles the outlet size of the stock manifold while minimizing the impact of the initial section of the number one injector line. These design features amount to a 49.4% increase in flow over the factory manifold. With this vast improvement over the stock manifold you can expect quicker turbo spool, lower EGT's, and less over all strain on your motor. This manifold also includes instructions, a polished stainless dipstick mount, port plugs, a factory Cummins gasket and hardware to make installing this intake extremely easy. You will need to delete all of your factory emissions equipment as the manifold does not have provisions to use any of it. This manifold is for off road use only.

The Pusher intercooler tube is built around 3.5" mandrel bent .060" thick tubing. This tube helps optimize your factory intake plumbing by replacing the stock 2.4" ID plastic tube. This kit also includes heavy duty 4-ply silicone couplers and stainless T-bolt clamps to make installing this tube extremely easy. When using this kit, you do not have to try and cut the factory steel band off your tube in order to save the factory boots. Just loosen the factory clamps and install the supplied parts.

  • 50-200 degree Farhenheit drop in EGT's
  • .5-1 MPG increase
  • Deletes constrictive emissions equipment
  • Significant gain in throttle response
  • Faster turbo spool

Note: You will need to delete all of your factory emissions equipment as the manifold does not have provisions to use any of it. This manifold is for off road use only.


  • MFG. Number67KIT2G
  • Manufacturer NamePusher
  • Shipping Weight15.00 lb.


Be the first to rate this item!

Write Review

Customer Photos

Customer Photos

See what others built Submit your photo

Questions and Answers

Ask XDP a Question about this product (Allow 24-48 hours for reply)

Most Popular Questions

Is this asking for the mounting ports or ports to connect gauges?
View Staff Answer 

This is giving you’re the option to choose the number of ports for gauges, water methanol injection, etc.

Emissions Notice

This product is not legal for sale or street use in California. Certain aftermarket products are subject to governmental emission standards regulated by the California Air Resources Board. In order for these products to be legal on a specific vehicle in California, the part number must receive a CARB Executive Order (EO) number. This number makes the part legal for use only on specific years, makes and models of vehicles. A decal with CARB EO number for these parts must be displayed in the engine bay to satisfy smog inspection requirements.