Walker 235-91376 Camshaft Position (CMP) Sensor With Pigtail

Swap out the failed sensor and harness connector in your 2007 Dodge Sprinter 3.0L with a Walker 235-91376 Camshaft Position (CMP) Sensor With Pigtail from XDP. The Cam Position Sensor can be located on the front or back of the engine block or the cylinder heads. Cam and Crank Position Sensors work with the vehicle's ECU to ensure that ignition timing and fuel supply are correct for peak fuel economy, performance, and emissions. Typically, your vehicle's Check Engine Light will illuminate on your dash telling you there is a code in the computer.
There are a number of reasons why a CMP sensor may fail. After millions of Cam and Crank rotations, the internal magnets of the sensor weaken causing poor signal transmission. A poor signal can cause improper timing between the Cam and Crank Sensor causing a check engine light and/or vehicle not starting. The repetition of extreme heat and cold, known as "heat cycling", breaks down internal circuitry. High mileage and/or poor maintenance causes an increase in tolerance stacking, resulting in sensors contacting internal rotating components. Faulty wiring and damaged connectors from heat cycling and other contaminants.

Walker Product's FSK program provides the ability to fix the vehicle the first time and not make multiple trips to the store to get what you need. Walker Products full-service kit contains not only the base sensor but also provides the mating connector and pigtail. Also included are butt splices and heat shrink to ensure a water-tight connection. For situations where the sensor and vehicle harness are faulty, an FSK offers a complete repair solution. The repetition of extreme heat and cold, known as "heat cycling", breaks down internal circuitry in the sensor but also deteriorates the connector and harness. Other contaminants such as oil and road debris also lead to connector and harness failures. When installing a Walker Products replacement sensor, the mating connector and harness could inadvertently be damaged during the process. For the DIY'er it saves a trip back to the parts store, dealership, or salvage yard to buy the mating connector and pigtail. Walker Products CMP/CKP sensors are 100% programmed and tested. Walker Products works continuously to stay current on all OE design changes, TSBs, and improvements to the OE design to make the best part for your vehicle.

Features:

• Designed To Hold Up Under Any Condition
• Manufactured With The Highest Quality Materials
• 100% Engineered & Tested To OE Spec In Fit, Form & Function
• Includes Pigtail Connector, Butt Splices, & Heat Shrink

Manufacturer Warranty*:
90 Day Limited