AFE BladeRunner Air Intake Manifold 46-10051
List Price: $373.75
XDP Price: $269.10
You Save: $104.65 (28 %)
Manufacturer Number: 46-10051
XDP Part Number: AFE46-10051
94-98 Dodge 5.9L Cummins 12V (excl. trucks w/ Hydro Brake Booster)
|The Bladerunner intake manifold represents the next generation in intake manifold design. The Bladerunner intake manifold uses a unique MDV (Multiple Directional Vane) technology to guide the air through the manifold maximizing air flow. Constructed out of cast A356-T6 aluminum and uses a proprietary internal bolt design to help increase the flow and provide a solid seal void of leaks or deformaties. the Bladerunner comes with up to 5 ports for nitrous injections, gauges and other accessories used by hardcore enthusiasts. In recent testing the Bladerunner intake manifold outflowed the factory intake by 32.9% and produced 17hp and 50lbs. x ft torque.
- Improves torque up to 15 lbs x ft
- Increases horsepower up to 5 HP
- Better turbo spool-up
- Better throttle response
- Lowers Exhaust Gas Temperatures
- Perfect complement with your turbo upgrade
- Patent Pending Multiple Directional Vane (MDV) Technology
- Superior internal cross section with turning vanes increases intake air flow vs. stock intake manifold
- Back side is pre-tapped with 2 1/8" NPT ports for easy and clean gauge installation and other auxiliary inputs
- Stainless Steel Hardware
- Will not void warranty
- C.A.R.B EO# D-550-10
Pre-tapped for easy and clean gauge installation and other auxiliary inputs
Stock Dodge Cummins intake manifolds have sharp bends and corners. Air flows around these corners and zones of dead air created. These dead air zones choke down air and restrict airflow to your engine.
The MDV™ Advantage
Our MDV™ technology uses smooth bends and directional vanes to form multiple air paths through the manifold. These new paths are smoother and shorter, producing much smaller dead air zones for increased overall airflow to the engine.
6/5/2012 2:01 PM
Turbo spools faster. Very happy with this product. Easy to install. I have had to remove it twice and it only takes about 5 minutes to pop it off. Pre-tapped ports for boost gauge was very nice!!
6/26/2011 11:47 AM
installation was easy, it twice the size of stock intake manifold, I'm running 50 degrees cooler, and gained a pound more boost, throttle response is a lot better, went from 22MPG to 24.5MPG. And it looks really nice under the hood.
( Lander wy)
4/13/2011 6:54 PM
One of the easiest modifications to do less than an hour to install. I really noticed some power increase,.going up an every day hill I was running around 50 degrees cooler and probably 10lbs of boost less. Great buy you will be satisfied.
4/19/2010 7:25 PM
looks great under the hood. felt a little extra get up going down the road. easy to install and is at least twice the size of the stock manifold so it really helps spread out the airflow over the cylinder bank. the only problem i had was that the allen wrench supplied with the kit isnt strong enough and it turned inside the bolt, but a stronger one from home depot did the job.