AFE Stage 2 Cold Air Intake System Type XP 54-10192

I have to say the folks at XDP are extremely helpful. This is just one of the three items purchased from them. I wanted intake, exhaust and programmer for no more than a 1,000$ they helped me with it and came out to less then 850$.The AFE Stage 2 intake was the first to come in, installed it, no problems. Hardware was good, not outstanding, the only thing I would have liked to seen different would be the banding clamps for the boot would have been better quality band clamps, was a bit worried they might give way when tightening.The only thing that was pain to fit up with the metal box was the temp sensor. When the rubber grommet was in the hole the sensor would not fit properly. I had to modify the grommet and use some electrical tape to get it to stay in the specified location.Other than those two things the install was effortless, the quality is GREAT, and the truck has a much different sound, turbo response is much better, and there is a noticeable increase in power. Not a huge increase but definitely noticeable. I am excited and look forward to the other products getting here, which is today, the MBRP 4" turbo back, and the TS 6-way tuner stock, high-idle, 50hp, 75hp, 100hp, 140hp.This product is worth the price here at XDP. Again, I am looking forward to complimenting this intake with the other components that are coming. Thank You XDP, you have given me, what seems like a new truck.Don

I have had other AFE intakes and have been very satisfied. This kit did not even come close to fitting properly. I had to relocate my brake proportioning valve below the intake. The cage hit it so it wouldn't sit down all the way. After I fixed that, I had to twist the whole metal cage to get the tube to line up. The tube flange and the cage are not at the same angle. I got it to line up, but it is in there under pressure. The holes for the bolts were too big and not enough washers were included, which would solve the problem. I had to get my own (not a huge problem.) The grommet didn't fit the holes properly. Also the grommet for the sensor didn't fit right. It is in there, but it is a round grommet for a sensor that normally twists and clicks in. I normally wouldn't complain if a product isn't exactly right but this did not seem like a normal AFE product, which is usually top notch. To end on a positive note, this intake brings in a lot more air. It cut down on my smoke and I can hear it sucking in air.

I had this installed along with an XDP compressor wheel and an Edge Juice with Attitude. Not sure how much the intake did by itself, but altogether it feels like I'm driving a totally different truck. Thanks aFe, my truck feels like new!