The S&B Filters 75-5104 Cold Air Intake with Cleanable Air Filter gives your 2011-2016 Ford 6.7L Powerstroke up to a 31.70% airflow improvement over the stock intake system. Designed as a bolt-on replacement, the S&B Intake System features a redesigned air box for a perfect fit and finish, and serious airflow gains.
Maximum Performance
The S&B cold air intake for the 2011-2016 Ford Powerstroke 6.7L was engineered to minimize air restriction and flows 31.70% better than stock. This kit comes with a fully enclosed airbox that protects the filter from dirt and keeps out engine heat.
New Snap In Lid Design
A new snap-In lid design requires no screws to secure it to the box. This makes installation and inspection quick and easy, as the filter can be installed and removed without having to remove the intake tube. Our silicone edge trim ensures an airtight seal, protecting against unwanted, power-robbing engine heat. This kit comes with a massive, highly-efficient air filter which results in better performance and protects your engine.
Less Restriction. More Airflow
The Intake Tube has minimal bends as it connects to the turbo inlet. It is positioned in one clean line with minimum obstructions from the turbo inlet to the intake box and air filter. This results in a decrease in restriction compared to stock.
Choose Your Airflow
The 75-5104 intake kit has (2) airflow configurations. S&B includes a silicone box plug that can be installed or removed depending on personal preference and airflow requirements.
Plug Removed: This configuration will provide an extra air inlet that will be pulled from the passenger side fender area.
Plug Installed: This configuration will seal the secondary air inlet located on the side of the box facing the vehicle fender. The front-facing grill inlet and the front scoop will become the main source of airflow into the Intake Box.
No Check Engine Lights
S&B devotes a huge amount of resources to engineer our intakes that allow your engine to run properly with stock calibration or enhanced tuning. An injection molded MAF plate in conjunction with a foam MAF sensor gasket ensures a true OE seal to the sensor.
Features:
- CARB EO# D-590-13
- New Snap In Lid Design
- No Check Engine Lights
- Cleanable & Reusable Filter
- Less Restriction. More Airflow
- Improves Airflow Over Stock By 31.70%
- 99.26% Efficient @ 580 CFM (ISO Coarse Dust)