Fleece Modified LB7 Intake Horn FPE-INTAKEHORN

Clean, nicely machined cast piece, with nice cutouts for the hard-to-reach lower bolts. Comes with nice gasket.,

Price was right! I wanted something that appeared stock in appearance and this fits the bill.I really appreciate the cuts on the lower bolt holes for future repairs. I can't speak on the HP gain,I did several mods at the time of install.

Great quality, all you need to do on a federal emissions LB7 is remove your air intake remove, remove the PCV bridge hose, remove the sensor nut on the intake and move over to the side. Then remove all three bolts on the turbo horn. Took me 20 min to do it. Tools you need: screw driver or 5/16 socket for the hose clamps, 45 degree need nose pliers or clamp tool for stock clamps on PCV bridge hose, 10mm ratchet wrench and telescoping magnet in case you drop a bolt in the valley. Happy Trucking!

Good build quality. Definitely will allow more air flow into the turbo. The truck definitely feels a little faster and turbo sounds a little louder. The 2 bottom bolts were super easy to get in because of the notches instead of the holes on the old one so you could thread the bolts in and slide the intake over them.

No hassle ordering. Shipping was great. Fit right in place. Very pleased. It will make it a lot easier next time I have to get in there.

Very easy install compared to other aftermarket intake horns. Fit right in place of oem which I imagine because the fleece is a oem that's been machined to a larger diameter.