0
No Products
RedHead Steering Gears 2764BS Steering Box (4-Bolt Cover)
PART#
2764BS | SKU RH2764BS
★★★★★
Vehicle Fitment For:
1999-2004 Ford F-250/350 | 2000-2005 Ford Excursion | 1999-2004 Ford E-Series Vans (36 Spline)
See full application list below
$426.00
FREE Delivery by ,
If you order within hr min
This product cannot be shipped to your destination
Not Shipping to ?
Need it faster?
Description
Gain control of your vehicle with proper steering when you add the RedHead Steering Gears 2764BS Steering Box (4-Bolt Cover) to your 1999-2004 Ford F-250/350 or 2000-2005 Ford Excursion (For Trucks With 36 Spline Sector Shaft). Made for a direct-fit replacement, this Steering Box does not require any modifications for installation. Family owned and operated, RedHead has more than 40 years of experience specializing in steering boxes. Remanufactured from quality materials, each RedHead Steering Box is built to be stronger than the OE unit.
Features:
- Remanufactured
- Direct-Fit Replacement
- Meets & Exceeds Factory Specs
- Shafts Are Flame Sprayed Or Replaced As Needed
- New Control Valves Installed On Some Applications
- Housing Are Machined And Needle Bearings Installed
- Sealing Surface Polished To A Higher Polish Than New
- Sector Shaft Checked On A Lathe For Straight And True
- Worm And Piston Assembled With New Precision Fit Steel Ball Bearings
SPECIFICATIONS:
Ratio: 18:1 (4 Turns)
Input: Single Flat With 27 Splines
Output: 36 Spline Sector 4 Master Spline
Fittings: O-Ring
Ratio: 18:1 (4 Turns)
Input: Single Flat With 27 Splines
Output: 36 Spline Sector 4 Master Spline
Fittings: O-Ring
Weight: 30.00 lbs
Notes:
Please verify what sector shaft you have prior to ordering.
Please verify what sector shaft you have prior to ordering.
If you have a 32 spline sector shaft, please see part# 2764.
Fits 2001-2004 Ford Super Duty trucks and 2000-2005 Ford Excursion.
For 1999 and 2000 please check sector shaft spline count. This unit has 36 splines.
Also fits the 1999-2000 Ford Super Duty trucks that have the 36 spline sector/output shaft.
All 2001-2004 Ford Super Duty's and 2001-2005 Excursion's came with the 36 spline sector from the factory.
Also fits the 1999-2000 Ford Super Duty trucks that have the 36 spline sector/output shaft.
All 2001-2004 Ford Super Duty's and 2001-2005 Excursion's came with the 36 spline sector from the factory.
For
reference please view the third picture - if you have 9 spline peaks
between each master spline, and there is 4 master splines, 9 times 4 =
36 splines
Common Questions
1. After installing the gearbox, fill the system with fluid.
2. Raise the front wheels off the ground, do not start the vehicle.
3. Work the steering wheel back and forth, lock to lock, 15-20 times.
4. Leave the vehicle sit (overnight is best) at least 2 hours
5. Top the pump reservoir off again.
6. Work the steering wheel back and forth again 7-10 times
7. Have a person in the vehicle and another at the pump reservoir with a container of fluid & funnel ready to pour if necessary.
8. Instruct the person in the vehicle to start the engine. As soon as this happens, if the fluid level drops, be ready to pour in more fluid. The level must be kept at an almost full level or it will suck in air again.
9. If this procedure is followed properly, the air problem will be solved.
WHAT POWER STEERING FLUID SHOULD I USE?
RedHead highly recommends using the same fluid that the manufacturer of your
vehicle recommends. It is always best to use a name-brand fluid. Their
power steering gears are tested under pressure with Dexron 3 ATF before
they leave the factory. If you decide to change from what the manufacturer
recommends then Dexron 3, or comparable fluid, is an acceptable alternative.
ARE REDHEAD GEARBOXES SENT OUT IN CENTER POSITION?
Yes, they are sent out on center.
Manufacturer Warranty*:
1 Year / Unlimited Mileage
1 Year / Unlimited Mileage
Instructions & Tech Info
Installation Info
Customer Average
2 Hours
Reviews For RedHead Steering Gears 2764BS
Overall Rating
/5
9 Reviews
Verified Buyer
It's OK but needed adjustment
KA (Evergreen) | May 2nd, 2026
Redhead steering gear for my 2002 F250 was purchased to replace the original gear, with 97K miles on it and lots of play. Redtop preload was adjusted too tightly, and there was significant resistance when trying to center. Wheels would not recenter and had major memory steer. Had to back off adjustment by >1/4 turn. Would not pay the price for this product again. Be advised, $65 to ship core back. Clever tactic on the warranty void if preload is changed. Either I adjust it or take it out and get another -possibly- bad adjusted gear from Redhead. This is not an XDP issue but a Redhead re-manu problem.
Write a Review
Review this product and help other XDP customers make informed decisions!
Frequently Asked Questions
What is the pitman arm torque spec?
The torque spec for the pitman arm on a 1999-2002 Ford Super Duty is 200 ft-lbs and the 2003-2004 model years is 225 ft-lbs.
How long do I have to return the core?
ReadHead has a 60-day core return policy; after 120 days, there is a $50 late fee, and after 1-year, they offer 50% credit.
Ask A Question
Ask a question about this product
Please allow up to 1 business day for reply.
Specifications For RedHead Steering Gears 2764BS
MPN
2764BS
SKU
RH2764BS
ID
105648
Manufacturer Name
RedHead Steering Gears
Shipping Weight
30.00 lb.
Shipping Length
9 in.
Shipping Width
11 in.
Shipping Height
13 in.
Fuel Type
Diesel / Gas
Manufacturer Warranty*
1 Year / Unlimited Mileage
Prop 65
WARNING: Cancer & Reproductive Harm - P65Warnings.ca.gov
WARNING: Cancer & Reproductive Harm - P65Warnings.ca.gov
Cross Reference #
2764-BS, 2764 BS
Internal
L13R20
ITEM ADDED TO CART
Complete the job with these highly suggested add-on products.
Product prices marked with an * may require additonal fees, such as a core charge, which will be displayed in the cart.